Filter
Top Products
D-Link DWS-1008 CLI Manual 245
clear dot1x tx-period
Resets to the default setting the number of seconds that must elapse before the switch retransmits
an EAP over LAN (EAPoL) packet.
Syntax: clear dot1x tx-period
Defaults: The default is 5 seconds.
Access: Enabled.
Examples: Type the following command to reset the EAPoL retransmission time:
DWS-1008# clear dot1x tx-period
success: change accepted
See Also:
• set dot1x tx-period
• show dot1x
set dot1x authcontrol
Provides a global override mechanism for 802.1X authentication configuration on wired
authentication ports.
Syntax: set dot1x authcontrol {enable | disable}
enable Allows all wired authentication ports running 802.1X to use the
authentication specified per port by the set dot1X port-control
command.
disable Forces all wired authentication ports running 802.1X to unconditionally
accept all 802.1X authentication attempts with an EAP Success
message (ForceAuth).
Defaults: By default, authentication control for individual wired authentication is enabled.
Access: Enabled.
Usage: This command applies only to wired authentication ports.
Examples: To enable per-port 802.1X authentication on wired authentication ports, type the
following command:
DWS-1008# set dot1x authcontrol enable
success: dot1x authcontrol enabled.