Filter
Top Products
D-Link DWS-1008 CLI Manual 247
set dot1x key-tx
Enables or disables the transmission of encryption key information to the supplicant (client) in
EAP over LAN (EAPoL) key messages, after authentication is successful.
Syntax: set dot1x key-tx {enable | disable}
enable Enables transmission of encryption key information to clients.
disable Disables transmission of encryption key information to clients.
Defaults: Key transmission is enabled by default.
Access: Enabled.
Examples: Type the following command to enable key transmission:
DWS-1008# set dot1x key-tx enable
success: dot1x key transmission enabled.
See Also:
• show dot1x
set dot1x max-req
Sets the maximum number of times the switch retransmits an EAP request to a supplicant (client)
before ending the authentication session.
Syntax: set dot1x max-req number-of-retransmissions
number-of-retransmissions Specify a value between 0 and 10.
Defaults: The default number of EAP retransmissions is 2.
Access: Enabled.
Usage: To support SSIDs that have both 802.1X and static WEP clients, MSS sends a maximum
of two ID requests, even if this parameter is set to a higher value. Setting the parameter to a
higher value does affect all other types of EAP messages.
Examples: Type the following command to set the maximum number of EAP request
retransmissions to three attempts:
DWS-1008# set dot1x max-req 3
success: dot1x max request set to 3.