Filter
Top Products
D-Link DWS-1008 CLI Manual 242
clear dot1x port-control
Resets all wired authentication ports on the switch to default 802.1X authentication.
Syntax: clear dot1x port-control
Defaults: By default, all wired authentication ports are set to auto and they process authentication
requests as determined by the set authentication dot1X command.
Access: Enabled.
Usage: This command is overridden by the set dot1x authcontrol command. The clear dot1x
port-control command returns port control to the method configured. This command applies
only to wired authentication ports.
Examples: Type the following command to reset the wired authentication port control:
DWS-1008# clear dot1x port-control
success: change accepted
See Also:
• set dot1x port-control
• show dot1x
clear dot1x quiet-period
Resets the quiet period after a failed authentication to the default setting.
Syntax: clear dot1x quiet-period
Defaults: The default is 60 seconds.
Access: Enabled.
Examples: Type the following command to reset the 802.1X quiet period to the default:
DWS-1008# clear dot1x quiet-period
success: change accepted
See Also:
• set dot1x quiet-period
• show dot1x