Filter
Top Products
D-Link DWS-1008 CLI Manual 280
show rfdetect data
Displays information about the APs detected by a switch.
Syntax: show rfdetect data
Defaults: None.
Access: Enabled.
Usage: You can enter this command on any switch. The output applies only to the switch on
which you enter the command. To display all devices that a specific D-Link radio has detected,
even if the radio is managed by another switch, use the show rfdetect visible command.
Only one MAC address is listed for each D-Link radio, even if the radio is beaconing multiple
SSIDs.
Examples: The following command shows the devices detected by this switch during the most
recent RF detection scan:
DWS-1008# show rfdetect data
Total number of entries: 197
Flags: i = infrastructure, a = ad-hoc
c = CCMP, t = TKIP, 1 = 104-bit WEP, 4 = 40-bit WEP, w = WEP(non-WPA)
BSSID Vendor Type Port/Radio Flags RSSI Age SSID
/Ch
----------------- ------- ----- ------------- ------ ---- --- -----------------
00:07:50:d5:cc:91 Cisco intfr 3/1/6 i----w -61 6 r27-cisco1200-2
00:07:50:d5:dc:78 Cisco intfr 3/1/6 i----w -82 6 r116-cisco1200-2
00:09:b7:7b:8a:54 Cisco intfr 3/1/2 i----- -57 6
00:0a:5e:4b:4a:c0 3Com intfr 3/1/11 i----- -57 6 public
00:0a:5e:4b:4a:c2 3Com intfr 3/1/11 i-t1-- -86 6 trapezewlan
00:0a:5e:4b:4a:c4 3Com intfr 3/1/11 ic---- -85 6 trpz-ccmp
00:0a:5e:4b:4a:c6 3Com intfr 3/1/11 i-t--- -85 6 trpz-tkip
00:0a:5e:4b:4a:c8 3Com intfr 3/1/11 i----w -83 6 trpz-voip
00:0a:5e:4b:4a:ca 3Com intfr 3/1/11 i----- -85 6 trpz-webaaa
...