Filter
Top Products
D-Link DWS-1008 CLI Manual 54
For 802.1X clients, wired authentication works only if the clients are directly attached to the wired
authentication port, or are attached through a hub that does not block forwarding of packets from the
client to the PAE group address (01:80:c2:00:00:03). Wired authentication works in accordance with
the 802.1X specification, which prohibits a client from sending traffic directly to an authenticator’s MAC
address until the client is authenticated. Instead of sending traffic to the authenticator’s MAC address,
the client sends packets to the PAE group address. The 802.1X specification prohibits networking
devices from forwarding PAE group address packets, because this would make it possible for multiple
authenticators to acquire the same client.
For non-802.1X clients, who use MAC authentication, WebAAA, or last-resort authentication, wired
authentication works if the clients are directly attached or indirectly attached.
Examples: The following command sets port 5 for a wired authentication user:
DWS-1008# set port type wired-auth 5
success: change accepted.
Examples: The following command sets port 6 for a wired authentication user and specifies a
maximum of three simultaneous user sessions:
DWS-1008# set port type wired-auth 6 max-sessions 3
success: change accepted.
See Also:
• clear port type
• set port type