Filter
Top Products
D-Link DWS-1008 CLI Manual 366
Defaults: 104-bit WEP encryption is disabled by default.
Access: Enabled.
Usage: To use 104-bit WEP with WPA clients, you must also enable the WPA IE.
When 104-bit WEP in WPA is enabled in the service profile, radios managed by a radio profile
that is mapped to the service profile can also support non-WPA clients that use dynamic WEP.
To support WPA clients that use 40-bit dynamic WEP, you must enable WEP with 40-bit keys. Use
the set service-profile cipher-wep40 command.
Microsoft Windows XP does not support WEP with WPA. To configure a service profile to
provide dynamic WEP for XP clients, leave WPA disabled and use the set service-profile wep
commands.
To support non-WPA clients that use static WEP, you must configure static WEP keys. Use the
set service-profile wep key-index command.
Examples: The following command configures service profile sp2 to use 104-bit WEP
encryption:
DWS-1008# set service-profile sp2 cipher-wep104 enable
success: change accepted.
See Also:
• set service-profile cipher-ccmp
• set service-profile cipher-tkip
• set service-profile cipher-wep40
• set service-profile wep key-index
• set service-profile wpa-ie
• show service-profile
set service-profile cipher-wep40
Enables dynamic Wired Equivalent Privacy (WEP) with 40-bit keys, in a service profile.
Syntax: set service-profile name cipher-ccmp {enable | disable}
name
enable
disable
Service profile name.
Enables 40-bit WEP encryption for WPA clients.
Disables 40-bit WEP encryption for WPA clients.