Filter
Top Products
D-Link DWS-1008 CLI Manual 335
name
enable
disable
no-client
Defaults: Dynamic channel assignment is enabled by default.
Access: Enabled.
Usage: If you disable RF Auto-Tuning for channels, MSS does not dynamically set the channels
when radios are first enabled and also does not tune the channels during operation.
If RF Auto-Tuning for channels is enabled, MSS does not allow you to manually change
channels.
Examples: The following command disables dynamic channel tuning for radios in the rp2 radio
profile:
DWS-1008# set radio-profile rp2 auto-tune channel-config disable
success: change accepted.
See Also:
• set {ap | dap} radio channel
• set radio-profile auto-tune channel-holddown
• set radio-profile auto-tune channel-interval
• set radio-profile auto-tune power-config
• show radio-profile
Radio profile name.
Configures radios to dynamically select their channels when the radios are
started.
Configures radios to use their statically assigned channels, or the default
channels if unassigned, when the radios are started.
Configures radios to change channels regardless of client status. Without this
option, a radio changes the channel only if the radio does not have any active
clients on that channel.
set radio-profile auto-tune channel-holddown
Sets the minimum number of seconds a radio in a radio profile must remain at its current channel
assignment before RF Auto-Tuning can change the channel. The channel holddown provides
additional stability to the network by preventing the radio from changing channels too rapidly in
response to spurious RF anomalies such as short-duration channel interference.
Syntax: set radio-profile name auto-tune channel-holddown holddown rate