Filter
Top Products
D-Link DWS-1008 CLI Manual 524
reset
Resets a DWS-1008 switch’s hardware.
Syntax: reset
Defaults: None.
Access: Boot prompt.
Usage: After resetting the hardware, the reset command attempts to load a system image file
only if other boot settings are configured to do so.
Examples: To immediately reset the system, type the following command at the boot prompt:
boot> reset
D-Link Systems Bootstrap 1.17 Release
Testing Low Memory 1 ............
Testing Low Memory 2 ............
CISTPL_VERS_1: 4.1 <SanDisk> <SDP> <5/3 0.6>
Reset Cause (0x02) is COLD
D-Link Systems Bootstrap/Bootloader
Version 1.6.5 Release
Bootstrap 0 version: 1.17 Active
Bootloader 0 version: 1.6.5 Active
Bootstrap 1 version: 1.17
Bootloader 1 version: 1.6.3
Board Revision: 3.
Controller Revision: 24.
POE Board Revision: 1
POE Controller Revision: 6
BOOT Index: 0
BOOT TYPE: c
DEVICE: boot1:
FILENAME: default
FLAGS: 00000000
OPTIONS: run=nos;boot=0
See Also:
• boot