Filter
Top Products
D-Link DWS-1008 CLI Manual 278
Usage: This command is valid only on the seed switch
Examples: The following example displays countermeasures status:
DWS-1008# show rfdetect countermeasures
Total number of entries: 190
Rogue MAC Type Countermeasures IPaddr Port/Radio
Radio Mac /Channel
----------------- ----- ------------------ --------------- -------------
00:0b:0e:00:71:c0 intfr 00:0b:0e:44:55:66 10.1.1.23 dap 4/1/6
00:0b:0e:03:00:80 rogue 00:0b:0e:11:22:33 10.1.1.23 dap 2/1/11
The table below describes the fields in this display.
Field Description
Rogue MAC BSSID of the rogue.
Type
Classification of the rogue device:
• rogue—Wireless device that is on the network but is not supposed to be on the
network.
• intfr—Wireless device that is not part of your network and is not a rogue, but
might be causing RF interference with AP radios.
• known—Device that is a legitimate member of the network.
Countermeasures Radio
MAC
MAC address of the D-Link radio sending countermeasures against the rogue.
IPaddr
System IP address of the switch that is managing the AP that is sending or will
send countermeasures.
Port/Radio/Channel
Port number, radio number, and channel number of the countermeasures radio.
For a Distributed AP, the connection number is labeled dap. (This stands for
distributed ap.)
See Also:
• set radio-profile countermeasures
show rfdetect counters
Displays statistics for rogue and Intrusion Detection System (IDS) activity detected by the APs
managed by a switch.
Syntax: show rfdetect counters
Defaults: None.
Access: Enabled.