Filter
Top Products
D-Link DWS-1008 CLI Manual 303
The table below describes the fields in the show boot output.
Field Description
Configured boot version
Software version the switch will run next time the software is rebooted.
Configured boot image
Boot partition and image filename MSS will use to boot next time the software is
rebooted.
Configured boot
configuration
Configuration filename MSS will use to boot next time the software is rebooted.
Backup boot
configuration
The name of the configuration file to be used in the event that MSS cannot read the
configured boot configuration file next time the software is rebooted.
Booted version Software version the switch is running.
Booted image
Boot partition and image filename MSS used the last time the software was
rebooted. MSS is running this software image.
Booted configuration
Configuration filename MSS used to load the configuration the last time the software
was rebooted.
See Also:
• clear boot config
• reset system
• set boot configuration-file
show config
Displays the configuration running on the switch.
Syntax: show config [area area] [all]
area area Configuration area. You can specify one of the following:
• aaa
• acls
• ap
• arp
• eapol
• httpd
• ip
• ip-config
• l2acl
• log
• mobility-domain
• network-domain
• ntp
• portconfig
• port-group
• qos
• radio-profile
• rfdetect
• service-profile
• sm
• snmp
• snoop