Filter
Top Products
D-Link DWS-1008 CLI Manual 43
Access: Enabled.
Examples: The following command configures Distributed AP 1 for AP model MP-372 with
serial-ID 0322199999:
DWS-1008# set dap 1 serial-id 0322199999 model mp-372
success: change accepted.
The following command removes Distributed AP 1:
DWS-1008# clear dap 1
This will clear specified DAP devices. Would you like to continue? (y/n)
[n]y
See Also:
• clear dap
• clear port type
• set port type ap
• set system countrycode
set port
Administratively disables or reenables a port.
Syntax: set port {enable | disable} port-list
enable
disable
port-list
Defaults: All ports are enabled.
Access: Enabled.
Usage: A port that is administratively disabled cannot send or receive packets. This command
does not affect the link state of the port.
Examples: The following command disables port 4:
DWS-1008# set port disable 4
success: set “disable” on port 4
Enables the specified ports.
Disables the specified ports.
List of physical ports. MSS disables or reenables all the specified ports.