Filter
Top Products
D-Link DWS-1008 CLI Manual 272
See Also:
• clear rfdetect ignore
• show rfdetect ignore
set rfdetect log
Disables or reenables generation of log messages when rogues are detected or when they
disappear.
Syntax: set rfdetect log {enable | disable}
enable Enables logging of rogues.
disable Disables logging of rogues.
Defaults: RF detection logging is enabled by default.
Access: Enabled.
Usage: The log messages for rogues are generated only on the seed and appear only in the
seed’s log message buffer. Use the show log buffer command to display the messages in the
seed switch’s log message buffer.
Examples: The following command enables RF detection logging for the Mobility Domain
managed by this seed switch:
DWS-1008# set rfdetect log enable
success: rfdetect logging is enabled.
See Also:
• show log buffer
set rfdetect signature
Enables AP signatures. An AP signature is a set of bits in a management frame sent by an AP
that identifies that AP to MSS. If someone attempts to spoof management packets from a D-Link
AP, MSS can detect the spoof attempt.
Syntax: set rfdetect signature {enable | disable}
enable Enables AP signatures.
disable Disables AP signatures.
Defaults: AP signatures are disabled by default.
Access: Enabled.