Filter
Top Products
D-Link DWS-1008 CLI Manual 453
Defaults: By default, no ports are static multicast router ports.
Access: Enabled.
Usage: You cannot add AP access ports or wired authentication ports as static multicast ports.
However, MSS can dynamically add these port types to the list of multicast ports based on
multicast traffic.
Examples: The following command adds port 5 as a static multicast router port:
DWS-1008# set igmp mrouter port 5 enable
success: change accepted.
The following command removes port 5 from the static multicast router port list:
DWS-1008# set igmp mrouter port 5 disable
success: change accepted.
See Also:
• show igmp mrouter
set igmp mrsol
Enables or disables multicast router solicitation by a switch on one VLAN or all VLANs.
Syntax: set igmp mrsol {enable | disable} [vlan vlan-id]
enable Enables multicast router solicitation.
disable Disables multicast router solicitation.
vlan vlan-id VLAN name or number. If you do not specify a VLAN, multicast router
solicitation is disabled or enabled on all VLANs.
Defaults: Multicast router solicitation is disabled on all VLANs by default.
Access: Enabled.
Examples: The following command enables multicast router solicitation on VLAN orange:
DWS-1008# set igmp mrsol enable vlan orange
success: change accepted.
See Also:
• set igmp mrsol mrsi