Filter
Top Products
D-Link DWS-1008 CLI Manual 239
set server group load-balance
Enables or disables load balancing among the RADIUS servers in a server group.
Syntax: set server group group-name load-balance {enable | disable}
group-name Server group name of up to 32 characters.
load-balance Enables or disables load balancing of authentication requests among
enable | disable the servers in the group.
Defaults: Load balancing is disabled by default.
Access: Enabled.
Usage: You can optionally enable load balancing after assigning the server group members. If
you configure load balancing, MSS sends each AAA request to a separate server, starting with
the first one on the list and skipping unresponsive servers. If no server in the group responds,
MSS moves to the next method configured with set authentication and set accounting.
In contrast, if load balancing is not configured, MSS always begins with the first server in the list
and sends unfulfilled requests to each subsequent server in the group before moving on to the
next configured AAA method.
Examples: To enable load balancing between the members of server group shorebirds, type the
following command:
DWS-1008# set server group shorebirds load-balance enable
success: change accepted.
To disable load balancing between shorebirds server group members, type the following
command:
DWS-1008# set server group shorebirds load-balance disable
success: change accepted.
See Also:
• clear server group
• clear radius server
• set server group
• show aaa