Filter
Top Products
D-Link DWS-1008 CLI Manual 397
The following Table describes the fields in this display.
Field Description
port
DWS-1008 port number.
Note: This field is applicable only if the DWL-8220AP is directly connected to the
DWS-1008 and the DWS-1008’s port is configured as an AP access port.
DAP
Connection ID for the Distributed AP.
This field is applicable only if the AP is configured on the DWS-1008 as a Distributed
AP.
serial-id
Serial ID of the DWL-8220AP access point.
Note: This field is displayed only for Distributed APs.
AP Model
Access point mdel number.
POE
PoE state on the DWS-1008 port:
• Enable
• Disable
name DWL-8220AP access point name.
fingerprint
Hexadecimal fingerprint of the AP’s public encryption key.
Note: This field is displayed only for Distributed APs. If the field is blank, the key has
not been verified yet by an administrator.
boot-download-enable
State of the firmware upgrade option:
• YES (automatic upgrades are enabled)
• NO (automatic upgrades are disabled)
force-image-download
State of the option to force the AP to download a new image:
• YES (automatic upgrades are enabled)
• NO (automatic upgrades are disabled)
load balancing group
Names of the AP load-balancing groups to which the DWL-8220AP access point
belongs. If the value is None, the access point does not belong to any load balancing
groups.
location Location information for the AP.
contact Contact information for the AP.
Radio
Radio number. The information listed below this field applies specifically to the radio.
type
Radio type:
• 802.11a
• 802.11b
• 802.11g
channel
Channel number.
antennatype External antenna model, if applicable.
tx pwr Transmit power, in dBm.
profile
Radio profile that manages the radio. Until you assign the radio to a radio profile,
MSS, assigns the radio to the default radio profile.
auto-tune max-power
Maximu power level the RF Auto-Tuning feature can set on the radio:
• The value default means RF Auto-Tuning can set the power up to the maximum level
allowed for the country of operation.
• A specific numeric value means you or another administrator set the maximum
value.