Filter
Top Products
D-Link DWS-1008 CLI Manual 422
Field Description
RTS Threshold
Minimum length (in bytes) a frame can be for a radio in the radio profile to use
the RTS/CTS method to send the frame. The RTS/CTS method clears the air
of other traffic to avoid corruption of the frame due to a collision with another
frame.
Frag Threshold
Maximum length (in bytes) a frame is allowed to be without being fragmented
into multiple frames before transmission by a radio in the radio profile.
Long Preamble
Indicates whether an 802.11b radio that uses this radio profile advertises support
for frames with long preambles only:
• YES—Advertises support for long preambles only.
• NO—Advertises support for long and short preambles.
Tune Channel
Indicates whether RF Auto-Tuning is enabled for dynamically setting and tuning
channels.
Tune Power
Indicates whether RF Auto-Tuning is enabled for dynamically setting and tuning
power levels.
Tune Channel Interval
Interval, in seconds, at which RF Auto-Tuning decides whether to change the
channels on radios in a radio profile. At the end of each interval, MSS processes
the results of the RF scans performed
during the previous interval, and changes radio channels if needed.
Tune Power Interval
Interval, in seconds, at which RF Auto-Tuning decides whether to change
the power level on radios in a radio profile. At the end of each interval, MSS
processes the results of the RF scans performed during the previous interval,
and changes radio power levels if needed.
Power ramp interval
Number of seconds a radio waits before increasing or decreasing
its power by 1 dBm in response to a power change from RF
Auto-Tuning. After each power ramp interval, the radio increases or decreases
the power by another 1 dB until the radio reaches the power level selected by
RF Auto-Tuning.
Channel Holddown
Minimum number of seconds a radio in a radio profile must remain at its current
channel assignment before RF Auto-Tuning can change the channel.
Countermeasures
Indicates whether countermeasures are enabled.
Active-Scan
Indicates whether the active-scan mode of RF detection is enabled.
RFID enabled
Indicates whether AeroScout tag support is enabled.
WMM Powersave
Indicates whether U-APSD support is enabled.
QoS Mode
Indicates the Quality-of-Service setting for AP radio forwarding queues:
• wmm—AP forwarding queues provide standard priority handling for WMM
devices.
• svp—AP forwarding queues are optimized for SpectraLink Voice Priority
(SVP).
Service profiles
Service profiles mapped to this radio profile. Each service profile contains an
SSID and encryption information for that SSID.