Filter
Top Products
D-Link DWS-1008 CLI Manual 457
set igmp qri
Changes the IGMP query response interval timer on one VLAN or all VLANs on a switch.
Syntax: set igmp qri tenth-seconds [vlan vlan-id]
qri tenth-seconds Amount of time (in tenths of a second) that the switch waits for a receiver
to respond to a group-specific query message before removing the receiver
from the receiver list for the group. You can specify a value from 1 through
65,535.
vlan vlan-id VLAN name or number. If you do not specify a VLAN, the timer change applies
to all VLANs.
Defaults: The default query response interval is 100 tenths of a second (10 seconds).
Access: Enabled.
Usage: The query response interval is applicable only when the switch is querier for the subnet.
For the switch to become the querier, the pseudo-querier feature must be enabled on the switch
and the switch must have the lowest IP address among all the devices eligible to become a
querier. To enable the pseudo-querier feature, use set igmp querier.
Examples: The following command changes the query response interval on VLAN orange to 50
tenths of a second (5 seconds):
DWS-1008# set igmp qri 50 vlan orange
success: change accepted.
See Also:
• set igmp lmqi
• set igmp oqi
• set igmp qi
• set igmp querier
• set igmp rv