Filter
Top Products
D-Link DWS-1008 CLI Manual 332
Examples: The following command configures the transmit power on the 802.11a radio on the
DWL-8220AP access point connected to port 5:
DWS-1008# set ap 5 radio 1 tx-power 10
success: change accepted.
The following command configures the channel and transmit power on the 802.11b/g radio on the
DWL-8220AP access point connected to port 2:
DWS-1008# set ap 2 radio 1 channel 1 tx-power 10
success: change accepted.
set dap security
Sets security requirements for management sessions between a DWS-1008 switch and
its Distributed APs. This feature applies to Distributed APs only, not to directly connected
DWL-8220APs configured on DWL-8220AP access ports. In addition, DWL-8220AP models
DWL-8220AP-101 and DWL-8220AP-122 do not have encryption keys and do not support this
feature regardless of how they are connected to the switch.
Note: The maximum transmission unit (MTU) for encrypted DWL-8220AP management traffic
is 1498 bytes, whereas the MTU for unencrypted management traffic is 1474 bytes. Make sure
the devices in the intermediate network between the switch and Distributed AP can support the
higher MTU.
Syntax: set dap security {require | optional | none}
require
optional
none
Defaults: By default, encryption keys are optional.
Access: Enabled.
Usage: This parameter applies to all Distributed APs managed by the switch. If you change the
setting to required, the switch requires Distributed APs to have encryption keys. The switch also
requires their fingerprints to be confirmed in MSS. When DWL-8220AP security is required, an
Require all Distributed APs to have encryption keys that have been confirmed
in the CLI by an administrator.
Allows DWL-8220APs to be managed by the switch even if they do not have
encryption keys or their keys have not been configured by an administrator.
Encryption is not used, even for APs that support it.