Filter
Top Products
D-Link DWS-1008 CLI Manual 354
Parameter Default Value Radio Behavior When Parameter Set to Default Value
psk-phrase No passphrase defined
Uses dynamically generated keys rather than statically configured
keys to authenticate WPA clients.
psk-raw
No preshared key
defined
Uses dynamically generated keys rather than statically configured
keys to authenticate WPA clients.
rsn-ie disable
Does not use the RSN IE in transmitted frames. (The RSN IE is
required for 802.11i. RSN is sometimes called WPA2.)
shared-key-auth disable
Does not use shared-key authentication.
This parameter does not enable PSK authentication for WPA. To
enable PSK encryption for WPA, use the set radio-profile auth-
psk command.
short-retry-count 5
Sends a short unicast frame up to five times without
acknowledgment.
soda disable
Sygate On Demand Agent (SODA) files are not downloaded to
connecting clients.
ssid-name dlink
Uses the SSID name dlink.
static-cos disable
Assigns CoS based on the Qos mode (wmm or svp) or based on
ALCs.
tkip-me-time 6000
Uses Michael countermeasures for 60,000ms (60 seconds)
followin detertion of a second MIC failure within 60 seconds.
transmit-rates
802.11a:
• mandantory: 6.0, 12.0, 24.0
• beacon rate: 6.0
• multicast-rate: auto
• disabled: none
802.11b:
• mandantory: 1.0, 2.0
• beacon rate: 2.0
• multicast-rate: auto
• disabled: none
802.11g:
• mandantory: 1.0, 2.0, 5.5,
11.0
• beacon rate: 2.0
• multicast-rate: auto
• disabled: none
Accepts associations only from clients that support one of the
mandantory rates.
Sends beacons at the specified rate (6Mbps for 802.11a, 2Mbps
for 802.11b/g.
Sends multicast data at the highest rate that can reach all clients
connected to the radio.
Accepts frames from clients at all valid data rates. (No rates are
disabled by default.)
Table: Defaults for Radio Profile Parameters (continued)