Filter
Top Products
D-Link DWS-1008 CLI Manual 289
Examples: The following commands back up the configuration file on a switch, reset the switch
to its factory default configuration, and reboot the switch:
DWS-1008# copy configuration tftp://10.1.1.1/backupcfg
success: sent 365 bytes in 0.401 seconds [ 910 bytes/sec]
DWS-1008# clear boot config
success: Reset boot config to factory defaults.
DWS-1008# reset system force
...... rebooting ......
copy
Performs the following copy operations:
• Copies a file from a TFTP server to nonvolatile storage.
• Copies a file from nonvolatile storage or temporary storage to a TFTP server.
• Copies a file from one area in nonvolatile storage to another.
• Copies a file to a new filename in nonvolatile storage.
Syntax: copy source-url destination-url
source-url Name and location of the file to copy. The uniform resource locator
(URL) can be one of the following:
• [subdirname/]filename
• file:[subdirname/]filename
• tftp://ip-addr/[subdirname/]filename
• tmp:filename
For the filename, specify between 1 and 128 alphanumeric characters,
with no spaces. Enter the IP address in dotted decimal notation.
The subdirname/ option specifies a subdirectory.
destination-url Name of the copy and the location where to place the copy. The URL
can be one of the following:
• [subdirname/]filename
• file:[subdirname/]filename
• tftp://ip-addr/[subdirname/]filename
If you are copying a system image file into nonvolatile storage, the
filename must include the boot partition name. You can specify one
of the following:
• boot0:/filename
• boot1:/filename
Defaults: None.
Access: Enabled.