Filter
Top Products
D-Link DWS-1008 CLI Manual 21
Usage: Use this command if the output of a CLI command is greater than the
number of lines allowed by default for a terminal type.
Examples: To set the number of lines displayed to 100, type the following command:
DWS-1008# set length 100
success: screen length for this session set to 100
set license
Installs an upgrade license key on a DWS-1008 switch.
The DWS-1008 can boot and manage up to 32 APs by default. You can increase the AP support
to 64, 96, or 128 APs, by installing one or more activation keys. You can install a 32-AP upgrade,
64-AP upgrade, or 96-AP upgrade. If you have already installed a 32-AP or 64-AP upgrade, you
can still install additional upgrades.
Syntax: set license activation-key
activation-key
Defaults: None.
Access: Enabled.
Usage: This command applies to the DWS-1008.
Examples: To install an activation key for an additional 80 APs, type the following command:
DWS-1008# set license 3B02-D821-6C19-CE8B-F20E
success: license accepted
See Also:
• show licenses
Hexadecimal digits generated by the D-Link license server or otherwise
provided by D-Link for your switch.
The activation key is based on the switch’s serial number.
You can enter the number in either of the following formats:
xxxx-xxxx-xxxx-xxxx-xxxx
xxxxxxxxxxxxxxxxxxxx