Filter
Top Products
4−2 Installation and Maintenance Volume
Octel 200/300 S.4.1 PB60019−01
8. Lift the cabinet straight up, until the stabilizer legs have cleared the server. Lift the server off the
pallet toward the pallet opening at the front of the server.
9. Place the server in its permanent location.
10. Replace the front door.
11. When the Octel 200/300 is installed, adjust the levelers until the top of the server is level and does not
wobble. No special tools are required to adjust the leveling, although a bubble level is recommended
for this purpose.
12. Collect and save all packing material, cartons, foam inserts, shipping pallet, etc., as they can be reused
to ship the server back to Avaya if any shipping damage was incurred.
Reshipping
If the Octel 200/300 is to be reshipped from your location, use the original shipping carton, and perform
the following:
1. Verify that all server assemblies are secure.
a. All boards must be seated and secured with locking ejectors.
b. All captive fasteners on the disk drive, power supply, and fan assemblies must be secured to the
cabinet with a flat-blade screwdriver.
2. Remove cabinet front door by opening the door and pulling it straight up, until it is free of the two
hinges.
3. Remove the front pallet section and place the server on the shipping pallet. This must be performed
by two people.
4. Replace and lock the front door.
5. Resecure the front pallet section against the front door, using two pallet bolts.
6. Replace the plastic bag over the cabinet.
7. Use a 7/16 inch wrench to replace the four brackets that secure the server to the pallet. The brackets
are located at the base of the server.
8. Replace the door key and power supply cord in the documentation bag and tape the bag to the top of
the cabinet.
9. Replace the foam insert, then the cardboard container.
10. Tape the top of the cardboard carton closed and secure it to the pallet with new strapping material.
Caution!
Do not transport the Octel 200/300 message server
unless it is secured on the shipping pallet in the
vertical, upright position.