Filter
Top Products
Hardware Replacement 9-25
Octel 200/300 S.4.1PB60019−01
Figure 9-16 Octel 200/300 Hard Disk Drive Assembly
Caution!
Hard disk drive assemblies are sensitive to static
electricity. Do not attempt the following procedures
without wearing an antistatic wrist strap.
Removing the Hard Disk Drive
To remove the hard disk drive, use the following procedures:
1. Unlock and open the door of the cabinet.
2. Put on an antistatic wrist strap. Connect it to an unpainted portion of the cabinet.
3. Locate the drive assembly to be removed.
4. Use a flat-blade screwdriver to loosen the two captive screws securing the disk assembly to the
cabinet.
5. Gripping the front flange, pull the drive assembly out of the cabinet. Use one hand to support the
bottom of the drive when it clears the cabinet.
6. Carefully place the drive assembly nearby, to be reinstalled or shipped.
. The hard disk drive assemblies are sensitive to rough handling. Be careful and handle them as
gently as possible.