Filter
Top Products
Quick Reference Guide
Octel 200/300
Maintenance Commands
Octel 200/300 S.4.1 PB60019−01
Command
Type
InformationCommandSubject
Test
Commands
(continued)
System Initialization TEC2xy
or
CUxyz
Initializes and cancels forwarding for all ports
specified. Sends initialization string from System
Parameter 33 —
PBX INITIALIZE CODE, then
cancels forward string from System Parameter 46
—
SYSTEM RELOAD CANCEL-FORWARD STRING.
x = slot number
y = port number or first port in a range of ports
z = port number of the last port in a range of ports
Floppy Disk Drive TE F 1 Isolates faults to floppy, disk drive or disk
controller.
Integration Card TE INT x y Tells the integration card to run its link selftest.
Used only for systems with integration cards.
x = slot number
y = unit number
LIC TE L 1 Checks tone generation and detection circuitry.
TE L 2 Ring-through test. Use only when no traffic.
TEL4x T est if loop current is present o n a specific port.
x = port number
TEL5x Tone reflection test on one port.
x = port number
Network Routes TE NET x y Tests network routes to a network location.
x = network location code (optional)
y = non-zero show digits entered
System Status TE S Checks voltages and temperatures.
Fax Application
Processor
TEXxyz Fax loopback test. Verifies fax modems on Fax
Application Processor can send and receive fax
data and that the TDM bus connection is correct.
x = slot number
y and z = fax channels