Filter
Top Products
6-40 Installation and Maintenance Volume
Octel 200/300 S.4.1 PB60019−01
Use the LIST HARDWARE command to list the Hardware Error Table after testing the alarm or enabling
remote access. At the @ prompt, enter:
LH
Enter
The Octel 200/300 prompts *** ALARM HAS BEEN GIVEN *** to indicate an alarm test was
performed. The command CLEAR HARDWARE clears this test message. At the @ prompt, enter:
CH
Enter
Caution!
You must clear the Hardware Error Table to reset the
Octel 200/300 callout feature, or the Octel 200/300
will not attempt to call the alarm number when a true
alarm occurs. If the Table shows other errors, refer to
the System Errors and Traffic Pegs chapter, Hardware
Errors section, in this volume.
. The TE A command also closes the Alarm Relay and turns ON the Alarm.
The CHcommand reopens the Alarm Relay and turns OFF the Alarm.
Figure 6-1 shows an alarm-test flow chart.