Filter
Top Products
Hardware 2-3
Octel 200/300 S.4.1PB60019−01
Octel 200 Cabinet
Each Octel 200 is shipped fully assembled. The cabinet specifications are as follows:
Height: 24.8 inches (63.0 cm) Clearances: Front: 22 inches (56 cm
Width: 13.0 inches (33.0 cm) Rear: 6 inches (15 cm)
Depth: 19.5 inches (49.5 cm) Side: 1 inch (2.5 cm)
Weight: 100 pounds (45.4 kg) maximum Top: 1 inch (2.5 cm)
Figure 2-1 through Figure 2-4 at the end of this section show various views and component locations
of the Octel 200.
Octel 200 Shelves
The Octel 200 has two shelves − Shelf A and Shelf B − with slots for various configurations of disk
drives and system cards.
Octel 200 Shelf A
Shelf A contains 10 card slots. Six of the slots can be used for Line Interface Cards (LICs) in any
combination, to a maximum of 64 ports. In addition, a maximum of 24 fax channels can be
supported. The following Table shows which cards can go into each slot.
Refer to the Product Description and Administration volume, General Description chapter, General
Octel 200/300 Sizing and Capacity section, for additional information. Refer to the Configuration
volume, Slots Table chapter, for information about configuring the slots.
Slot Number Cards
A1–A6 LIC, TLC, DAC, DLC16, ILIC12, DTIC, or integration cards
A1–A7 Fax card
A5–A7 LAN card
A7 EntryWorks ACP card
A8 VCU
A9 CPU
A10 (PSU, includes floppy disk load device)
Octel 200 Shelf B
Shelf B contains a slot for a Works for Serenade disk drive and three slots for system/voice disk
drives. The disk drive usage by slot number is as follows:
Slot Number Type of Disk Drive Installed
B1 Works for Serenade disk drive
B2 and B3* System/voice disk drives (data and voice storage)
B4 Voice disk drive
*Load the system/voice and voice disk drives into the slots in the following order: B2, B3, B4.
- For a single-drive, load the system/voice drive in slot B2
- With two drives, load the system/voice drives in slots B2 and B3
- With three drives, load the system/voice drives in slots B2 and B3 and a voice drive in slot B4.