Filter
Top Products
12-52 Installation and Maintenance Volume
Octel 200/300 S.4.1 PB60019−01
Hard Disk Remove
This section provides the procedures for removing a drive from a multiple-drive message server. This procedure
applies when you intend to remove a disk without immediately replacing it.
Action
Octel 200/300 Description and Response
Refer to the Hardware Replacement chapter, Hard Disk Drive
Replacement section, for Hard Disk Removal procedures. Hard disks may
be hot plugged.
The following screen appears.
Remove the Drive(s)
1. Forward ports.
2. Remove the hard disk(s) from
the system.
Boot the System
3. Make sure the software disk #1
(for the correct release level) is
write-protected.
4. Insert software disk #1 (for the
correct release level) into the
FD.
5. Adju st the b aud rate o f the
terminal/telepr inter . Refer to
Chap ter 4 , I ns tallation; T er minal
Communications section.
6. Press the Reload button to boot
from floppy disk.
7. Insert disk #2 when prompted.