Filter
Top Products
12-60 Installation and Maintenance Volume
Octel 200/300 S.4.1 PB60019−01
Hard Disk Restore
These procedures provide the steps to restore a message server when the Octel 200/300 is:
- Configured as a one-disk system and the hard disk needs replacement.
- Configured as a multiple-disk system and both of the system disks need replacement.
. When doing the Hard Disk Restore procedures, make sure that the disks being used are for the correct release
level.
. The Hard Disk Restore procedure will result in the loss of all recorded names, greetings, and messages. Use
the Hard Disk Copy procedure if information and recordings must be copied to new drives.
Action
Octel 200/300 Description and Response
Back up greetings, names, scripted and sequential messages, and Personal
Distribution List names.
Refer to the Backup and Restore of Greetings, Names, Scripted and
Sequential Messages, Personal Distribution List Names, and Prompts
section in this chapter.
Hard disks may be hot plugged.
Refer to the Hardware Replacement chapter, Hard Disk Drive
Replacement section, for Hard Disk Replacement procedures. Hard disks
may be hot plugged.
Two floppy disks are required to boot the Octel 200/300.
Preparation
Replace the Hard Disk
1. Forward ports.
2. Remove the hard disk(s)
to be replaced.
3. Install the replacement hard
disk(s).
4. Make sure software disks #1 and
#2 (for the correct release level)
are write-protected.
5. Insert software disk #1 into the
Floppy Drive (FD).