Procedures 12-71
Octel 200/300 S.4.1
PB60019−01
The following messages are printed
CPU Model 300−6039−001 Rev F1
486 Step 27 32MB
Testing Processor...PASSED
Testing System Voltage/Temp...PASSED
Testing ROM Checksum...PASSED
Testing PIT...PASSED
Testing DMA...PASSED
Testing UART...PASSED
Testing Modem...PASSED
Testing TDM Crosspoint...PASSED
Testing Floppy...PASSED
Testing RTC...PASSED
Testing BIC...PASSED
Testing OCC...PASSED
Testing WDT...PASSED
Testing Control Bus Interface...PASSED
Testing COMPLETED
Booting from SCSI file XBOOT.IM
Image loaded
Loading Image from Hard Disk
Loading file VMS1_3.IM
Loading file VMS2_3.IM
Loading file VMS3_3.IM
Image loaded
−−−−−− SYSTEM SOFTWARE RELEASE S.X.X.X (xx/xx/xx) −−−−−−
Copyright(c) YYYY Lucent Technologies All Rights Reserved.
TUE 11/08 08:44:58 YYYY ID: S/N:000000 PBX:00
(Modem enabled) (Telnet disabled) Last Logon : 00/00 00:00
@WAITING FOR VCU READY
LOADING VCU WITH FILE H:VCU.IM
VCU STARTED
RUNNING DISK REBUILD...REBUILD DONE
INITIALIZING PORTS...
PORT INITIALIZATION DONE
@
At this point the Octel 200/300 has completely booted from floppy disk.
To log on to system.
Reviews the status of all drive slots.
4. Adju st the b aud rate o f the
terminal/telepr inter . Refer to
Chap ter 4 , I ns tallation; T er minal
Communications section.
5. Press the Reload button to boot
from floppy disk.
6. Press .
Enter
7. @DSKMAP Enter