Filter
Top Products
INSTALL 1-5
Octel 200/300 S.4.1PB60019−01
Exiting the INSTALL Program
When the program is completed, INSTALL displays the following screen:
WARNING: FOR PROPER OPERATION SYSTEM MUST BE RESTARTED AFTER INSTALL!
INSTALL COMPLETE.
WAIT... DONE.
SAVE configuration to a DISKETTE? ( Y/N , empty line = N ).
:
DAY MM/DD HH:MM:SS YYYY NAME ID: S/N: PBX:
−−−−−−−− SYSTEM INSTALLATION COMPLETED −−−−−−−−
Answer Y to copy all the data onto the configuration diskette as a backup. The Octel 200/300 must
be reloaded after the INSTALL is complete.
To exit before you have completed the INSTALL program, at the colon (:) type:
.:E
Enter
When you type (.E) to exit, the portion of the completed configuration is saved to the hard disk. You
can continue the INSTALL later, from where you left off, or you can start over. Refer to the
Restarting INSTALL section or the Exiting and Continuing section of this chapter.
Modifying Tables While Using INSTALL
While using the INSTALL program, you can access the UPDATE program to list, add, modify, or
delete information in the configuration tables.
The INSTALL program displays a colon (:) when it is waiting for a response. At the colon, type a dot
(.), which is the UPDATE prompt, then an L (list), an A (add), an M (modify), or a D (delete),
followed by the name of the table you want to alter. For example,
:.A USER
The INSTALL program activates the UPDATE program. Alter the tables as necessary. To exit
UPDATE, press
Enter
at the colon. The INSTALL program resumes.