Filter
Top Products
Installation 4−25
PB60019−01 Octel 200/300 S.4.1
Using UPDATE
Use the UPDATE program to verify or modify the configuration database, as described in the following
two sections.
Verifying the Configuration Database
After you finish the message server configuration, the terminal again displays the @ prompt. To get a
printout of the database, enter the UPDATE program. At the @ prompt, enter
UP
Enter
The terminal displays the dot (.) prompt. At the dot, enter
L ALL
Check the printout with the configuration forms and verify that the data is correct. If correct, exit from
the program by typing
E
If any of the data is incorrect, follow the instructions in the Configuration volume to change the database.
When changes are made in the configuration database, always save the information to the backup disk
when you exit the UPDATE program. Answer Y when the Octel 200/300 asks whether you want to save
the configuration to disk.
Modifying the Configuration Database
You can modify, add, or delete message server configuration data. When the terminal or teleprinter
displays the @ prompt, enter:
UP and press
Enter
At the dot (.) prompt, enter an UPDATE command. Refer to the Configuration volume, UPDATE chapter.