Filter
Top Products
Log Commands 7-27
Octel 200/300 S.4.1PB60019−01
Transaction Types
To set specific transaction types, at the > prompt, enter the type of transaction and the status value. Refer
to Table 7-2 and Table 7-3 for the correct abbreviations, or use the LOG PF CDR command to display
the CDR log status and view the abbreviations. Refer to the Displaying CDR Type and Status
Configuration section.
A transaction type and a status value can be partially specified. When only the first letter (or two) is
entered, all types and values beginning with that letter are enabled. In the following example, only
transaction types beginning with CAL and status values beginning with B are set.
>E CAL B
>
LOG FILTERS MODIFIED
@LOG PF CDR
Specify Filters to PRINT:
<”E”nable or ”D”isable> <XA string or ”ALL”> <ST string or ”ALL”>
Empty line when done. ESCape to abort.
>ECB
CALMBX BUSY BADP BADM BLOK BADU
CALATT BUSY BADP BADM BLOK BADU
CALPA BUSY BADP BADM BLOK BADU
CALFLX BUSY BADP BADM BLOK BADU
CALNXT BUSY BADP BADM BLOK BADU
CALDID BUSY BADP BADM BLOK BADU
CALINT BUSY BADP BADM BLOK BADU
CALEXT BUSY BADP BADM BLOK BADU
CALIMM BUSY BADP BADM BLOK BADU
CALATD BUSY BADP BADM BLOK BADU
CALPAD BUSY BADP BADM BLOK BADU
CALHLP BUSY BADP BADM BLOK BADU
>
To disable transaction and status values from the CDR log, use the same command:
LOG MF CDR
Use the same procedure to disable transactions and status values, but add a D before specifying the filters
to modify.
D ALL ALL
@LOG MF CDR
Specify Filters to MODIFY:
<”E”nable or ”D”isable> <XA string or ”ALL”> <ST string or ”ALL”>
Empty line when done. ESCape to abort.
>D ALL ALL
>
LOG FILTERS MODIFIED