Filter
Top Products
12-68 Installation and Maintenance Volume
Octel 200/300 S.4.1 PB60019−01
To log on to the Octel 200/300.
The Octel 200/300 responds with the following:
−−−−−− −SYSTEM INSTALLATION DIALOG −−−−−−−−
DAY MM/DD HH:MM:SS YYYY ID:000 SN:000000 PBX:00
NEW CONFIGURATION INSTALLATION.
CLEARING ALL TABLES. . . DONE.
INITIALIZING ALL USER DIRECTORIES . . .
NOTE: Message Waiting setup 8:00 AM to 18:00 PM because
defaults were 0.
DONE.
The Octel 200/300 then gives the following messages to indicate the status
of the reinstall. Answer the questions. Refer to Configuration volume,
INSTALL chapter.
Do you wish to PRE−LOAD any table from a previous INSTALL
from your DISKETTE? ( Y/N, empty line = N )
:Y
Insert desired DISKETTE in drive. Press RETURN when ready...
PRE-LOAD ALL configuration tables?
:Y
Next, the Octel 200/300 prompts you to insert the disk.
When the pre-load is complete, the following message is printed:
TABLE PRE−LOAD COMPLETE
Do you wish to set the system DATE and TIME?(Y/N,empty line = N)
A series of messages is printed to indicate which tables have been
pre-loaded. On completion, the following messages are printed:
35. Press .
Enter password.
Enter
Reinstall the Configuration
36. After the Octel 200/300 has
booted from the hard disk, insert
the configuration backup disk
into the FD.
37. @INSTA
Enter