Filter
Top Products
Octel 200/300 S.4.1PB60019−01
CANADIAN USER INFORMATION
Industry Canada Certification No. 883-4105A
NOTICE
The Industry Canada label identifies certified equipment. This certification means that the equipment
meets certain telecommunications network protective, operational, and safety requirements. Industry
Canada does not guarantee the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities
of the local telecommunications company. The equipment must also be installed using an acceptable
method of connection. In some cases, the company’s inside wiring associated with a single line individual
service may be extended by means of a certified connector assembly (telephone extension cord). The
customer should be aware that compliance with the above conditions may not prevent degradation of
service in some situations. Communication cables provided by the user to connect to the
telecommunications network must be not less than 26 AWG copper.
Repairs should be performed by Lucent Technologies Corporation or an authorized representative of
Lucent Technologies Corporation or the warranty or service agreement could be void. In the event that
this equipment malfunctions, the telecommunications company may request that the equipment be
disconnected.
Users should ensure for their own protection that the electrical ground connections of the power utility,
telephone lines, and internal metallic water pipe system, if present, are connected together. This
precaution may be particularly important in rural areas.
CAUTION
Users should not attempt to make such connections themselves, but should contact the appropriate
electric inspection authority, or electrician, as appropriate. The equipment is installed by trained
personnel.
The Load Number (LN) assigned to each terminal device denotes the percentage of the total load to be
connected to a telephone loop which is used by the device, to prevent overloading. The termination on a
loop may consist of any combination of devices subject only to the requirement that the total of the Load
Numbers of all the devices does not exceed 100.
The load number of this product O200 / O300 is 19.
CANADIAN EMC STATEMENT
This Class A digital apparatus meets all the requirements of the Canadian Interference-Causing
Equipment Regulations (ICES).