Filter
Top Products
Procedures 12-41
Octel 200/300 S.4.1
PB60019−01
12.6 HARD DISK PROCEDURES
This section describes the procedures for restoring, replacing, adding, removing, and copying a hard disk drive, and
for upgrading languages. This section also describes the hard disk drive utility programs used while performing the
hard disk procedures.
Preparation
The following equipment is needed for the Hard Disk Procedures and should be assembled and verified prior to
starting.
- Replacement hard disk drive(s) as needed
- Software disks for the current release
- System prompt disks for the current release
. Verify that the software disks and system prompt disks are for the same software release.
- A terminal and printer (or terminal with hardcopy capability) for communicating with the Octel 200/300 and
for obtaining a printed copy of all message server inputs and responses
Procedures
The Hard Disk Procedures included in this section are
- ADD
To add a drive to a message server. Refer to Hard Disk Add in this section.
- REMOVE
To remove a drive from a multiple-drive message server. Refer to Hard Disk Remove in this section.
- REPLACE
To replace a disk drive in a multiple-drive message server. Refer to Hard Disk Replace in this section.
- RESTORE
To restore a message server to operation when system drive(s) must be replaced or the software is to be
updated. Refer to Hard Disk Restore in this section.
- COPY
To copy a drive’s contents to another drive. Refer to Hard Disk Copy in this section.
Commands
The utility programs used while performing the hard disk procedures are
- DSKMAP
- DSKTST
- DISKO