Filter
Top Products
8-34 Installation and Maintenance Volume
Octel 200/300 S.4.1 PB60019−01
Table 8-2 Hardware Error Types and Remedies (continued)
Error Type:Name PriorityRemedySource
64. LAN Hardware
Error (continued)
Problem detected by
the LAN.
Dependent on the DATA-1 values described
below.
3
C = DATA PACKET RECEIVED GOT CHECKSUM ERROR
Data communication is being corrupted between the local system and
the remote system at the location specified.
DATA-2 values as follows:
1 On open conn request received
2 On connless data packet
3 On data packet received
4 On connection grant received
5 On connection reject received
6 On a query packet received
7 Remote end had the cksum error
DATA-3 = LOW BYTE OF LOCATION
DATA-4 = UPPER BYTE OF LOCATION
REMEDY: The LAN guarantees that if a packet gets through, it
should be perfect, regardless of line conditions.
Therefore, this most likely points to a software problem.
Was the software recently changed or upgraded at either
location? If this continues, contact your technical support
center.
To determine the other location: Subtract 2 from the
number in Data-2 and Data-3 to get the location number
starting from 1. In
UPDATE, list the LOCATION Table to
determine the name of the corresponding location.
65 DMA Channel
Error
Problem with CPU
card
Replace CPU card 2
66. LAN Reported
Hardware Error
Problem detected by
the LAN.
Dependent on the DATA-1 values as
described below.
3
DATA-1 = ERROR CODE ON LAN:
01 = ERROR LOGGED PRIOR TO SYNC-UP WITH CPU SOFTWARE
REMEDY:
Contact your technical support center.