Filter
Top Products
8-28 Installation and Maintenance Volume
Octel 200/300 S.4.1 PB60019−01
Table 8-2 Hardware Error Types and Remedies (continued)
Error Type:Name PriorityRemedySource
42. Configuration
Error (continued)
Error detected in the
configuration tables
Check the configuration tables. 1
1D = REMOTE SYSTEM (NOT Octel 200/300) CONFIGURED TO
SUPPORT TURNAROUND
DATA-2 = LOCATION NUMBER OF REMOTE CABINET IN THE
LOCATION TABLE OF THE LOCAL CABINET
SOURCE:
The remote cabinet (not an Octel 200/300) is configured
to support turnaround. The remote cabinet is an Octel
250/350 or Octel PC, and in its node profile,
NODE
RESPONSE ALLOWED
has been set to YES for this node.
REMEDY: Modify the node profile in the remote cabinet and set
NODE RESPONSE ALLOWED to NO.
1E = NO QUERY REPLY POSSIBLE. Digital network is not up, do not have
domain feature, or both.
1F = DOMAIN FEATURE NOT AVAILABLE
DATA-2 = TYPE OF ERROR
= 1 = QUERIES BEING RECEIVED FROM FIELD
This means that some other system has this cabinet
configured in the domain.
DATA-3 = REMOTE HOST HANDLE OF THAT CABINET.
DATA-4 = UNUSED
20 = OctelNet serial # not configured.
22 = Sent a prefix the remote side did not recognize during Namesend.
23 = Other side does not have the Namesend feature.
24 = Generic Gateway error mailbox has not been configured but is required.
(System Parameter 285)
Go Dial went to initialization prompt.
25 = Names Directory error during Namesend.
26 = Multiple domain location configured with same IP address.
27 = Self numbering plan entry not configured, but matches Alternate self.
28 = Location for destination network mailbox not found. It is possible that the
network mailbox was in a distribution list and the location was deleted.
DATA-2 = First 8 digits of the network mailbox.
29 = No forwarding string defined (system parameter 45) for NPIC.
2a = gtfram error on sdisfrms table. This error is mostly caused by incorrect
configuration of the AP pool that should be an extended mailbox
DATA-2 = sysdist frame number that caused the problem
DATA-3 = Number of mailboxes in AP pool yet to scan
2b = Other side does not have the netname feature
DATA-2 = Location number
2c = SDL member configured to not receive messages
DATA-3 = User number
2d = Outcall digit string exceeds max (20 digits)
DATA-2 = Length of outcall number
DATA-3 = User number (0 may indicate network outcall)
2e = Invalid digit in outcall digits
DATA-2 = User number
DATA-3 = Position of invalid digit