Filter
Top Products
11-2 Installation and Maintenance Volume
Octel 200/300 S.4.1 PB60019−01
11.2 LAN INSTALLATION AND CONFIGURATION
Only one LAN card can be installed. The LAN card can be installed in slots A5, A6, or A7 for the
Octel 200 and slots A10, A11, or A12 for the Octel 300.
Perform the following steps for LAN installation and configuration:
1. Configure the LAN card number and card type in the SLOTS table. Refer to the Configuration
volume, SLOTS Table chapter.
2. In the LOCATION table, configure the IP address and SUBNET MASK fields for SELF.
−−−−−−−−−−−−−−−−−−−−−−−− SYSTEM CONFIGURATION UPDATE −−−−−−−−−−−−−−−−−−−−−−−−−
DAY MM/DD/YYYY 09:20:47 NAME ID:999999 S/N:200154 PBX: 10
At the dot (.), enter ? for HELP.
.m loc
Enter existing LOCATION NAME.
MOD: self
What is the PUBLIC SYSTEM NUMBER (CC#TC#SN#) for SELF ? (empty line = NONE)
MOD:
What is the PRIVATE SYSTEM NUMBER (0##N#) for SELF ? (empty line = NONE)
MOD:
Enter the OCTELNET SERIAL NUMBER for SELF.
MOD:
Enter the DIGITAL LOCATION NAME for SELF on the DIGITAL NETWORK (empty line =
NONE)
MOD: LUCENT_SVTC
Enter the IP ADDRESS for SELF on the DIGITAL NETWORK (empty line = NONE)
MOD: 148.147.24.235
Enter the SUBNET MASK for this DIGITAL NETWORK (empty line = 255.255.0.0)
MOD:
SELF saved
Enter existing LOCATION NAME
MOD:
.e
EXITING UPDATE.
WAIT...DONE.
SAVE configuration to a DISKETTE? (Y/N empty line = N)
FRI MM/DD/YYYY 09:21:43 NAME ID:999999 S/N:200154 PBX: 10
−−−−−−−−−−−−−−−−−−−−−−− CONFIGURATION UPDATE COMPLETED −−−−−−−−−−−−−−−−−−−−−−−
@
3. Modify system parameters as required for the LAN to communicate with the network.
4. Install the LAN card in its configured slot.
5. Restart the system.
. You cannot modify the SLOTS Table or the LOCATION Table when the LAN card is UP. Any
attempt to do so will result in the following error message. Refer to the section, Taking the LAN
Card Out of Service.
LAN is currently UP.
Please COURTESY DOWN the LAN board before doing this operation.