Filter
Top Products
153
Appendix C
E5jK Digital Controller Read Protocol
The E5jK Digital Controller Read Protocol reads and controls various parameters in remote mode for the Con-
troller connected to the Serial Communications Board via RS-232C or RS-485 cable.
Structure of the Protocol
The following table shows the structure of the E5jK Digital Controller Read Protocol.
Sequence Communications sequence Function
Ladder interface
No. name
Send word
allocation
Receive word
allocation
000 Read process value Reads the process value. Yes Yes
001 Read set point during SP ramp Reads the set point during SP
ramp.
Yes Yes
002 Read MV Reads the MV (heating, cooling). Yes Yes
003 Read set point Reads the set point. Yes Yes
004 Read alarm value Reads alarm value 1, 2. Yes Yes
005 Read proportional band, integral
time, and derivative time
Reads the proportional band, inte-
gral (reset) time, and derivative
(rate) time
Yes Yes
006 Read cooling coefficient Reads the cooling coefficient. Yes Yes
007 Read dead band Reads the dead band. Yes Yes
008 Read manual reset value Reads the manual reset value. Yes Yes
009 Read hysteresis Reads the hysteresis (heating,
cooling).
Yes Yes
010 Read control period Reads the control period (heating,
cooling).
Yes Yes
011 Read SP ramp time unit and set
value
Reads the SP ramp time unit and
SP ramp set value.
Yes Yes
012 Read LBA detection time Reads the LBA detection time. Yes Yes
013 Read MV at stop and PV error Reads the MV at stop and the MV
at PV error.
Yes Yes
014 Read MV limits Reads the MV limits. Yes Yes
015 Read input digital filter Reads the input digital filter. Yes Yes
016 Read alarm hysteresis Reads the alarm 1, 2 hysteresis. Yes Yes
017 Read input shifts Reads the input shift limits. Yes Yes
018 Read level 0 parameters Reads parameters in level 0. Yes Yes
019 Read level 1 parameters 1 Reads parameters in level 1. Yes Yes
020 Read level 1 parameters 2 Reads parameters in level 1. Yes Yes
021 Read level 2 parameters 1 Reads parameters in level 2. Yes Yes
022 Read level 2 parameters 2 Reads parameters in level 2. Yes Yes
023 General-purpose read Reads the value of the specified
parameter.
Yes Yes
Note Ladder Interface Settings
YES: User settings are required for the 2nd or 3rd operands of PMCR.
NO: Send word allocation: Set the constant 0000 for the 2nd operand (S).
Receive word allocation: Set a dummy word (e.g., DM 0000) address for the 3rd operand (D).