Filter
Top Products
Appendix K3Z4L Laser Micrometer Protocol
320
DIP Switch Settings
Shown below are the settings of 3Z4L-3000, 3Z4L-4000-series DIP switches required to use the system protocol
sequences.
3Z4L-3000 Series
• DIP Switch 1
No. Setting Status
1
Baud rate
ON/OFF
2 ON/OFF
3 Handshaking procedure ON/OFF
4
RS-232C interface use
ON/OFF
5
selection
ON/OFF
6 ON/OFF
• DIP Switch 2
No. Setting Status
1
Selection for
ON/OFF
2
measurement section
ON/OFF
3 ON/OFF
4 ON/OFF
5
Setting of minimum read
ON/OFF
6
value
ON/OFF
7 Setting of transparent
body measurement
function
ON/OFF
8 Setting of simultaneous
measurement function
ON/OFF
• DIP Switch 3
No. Setting Status
1
Setting of measurement
function by 2
ON/OFF
2
function by 2
measurement
instruments
ON/OFF
3 ON/OFF
4 ON/OFF
5 Error data exclusion
function
ON/OFF
6 Multistep selection
function
ON/OFF
3Z4L-4000 Series
• DIP Switch 1
No. Setting Status
1
Baud rate
ON/OFF
2 ON/OFF
3 Hand-shake procedure ON/OFF
4
Delimiter
ON/OFF
5 ON/OFF
6
RS-232C interface use
ON/OFF
7
selection
ON/OFF
8 ON/OFF
Set these settings according
to the sensor connected.
Set these settings for
4 digits in the decimal por-
tion.
This protocol does not sup-
port the error data exclusion
function