Filter
Top Products
Appendix NHayes Modem AT Command Protocol
406
MD144FB5V (OMRON)
The following command is set in the words specified by the second operand of PMCR.
ATE0V0X4\V2\N3%C0*C0\Q0&M0&D0%B9600S26=10
Character string length of modem initialization command (bytes)
Code length of PMCR when it is used (words)
ATE0V0X4\V2\N3%C
0*C0
\Q
0&M0
&D
0%B9
00410023
600S
26
=10
ME1414VBII/ME1414BII (OMRON)
The following command is set in the words specified by the second operand of PMCR.
AT\J1B8E0V0S0=1X4\V2\N3&M0%C0&D0&E0\X1S26=10
Character string length of modem initialization command (bytes)
Code length of PMCR when it is used (words)
AT \J1B8E0V0S0=1X
4\V2
\N
3&M0
%C
0&D0
00440024
&E0\
X1
S26=
10
Note Turn ON DIP switch SW3 on in the rear of the Modem.
Dialling
To dial telephone numbers for the OMRON Modems using sequences No. 561, 571, 581, set the dialling command
and telephone number in the words specified by the second operand of PMCR. However, for other Modems, make
the following settings for the Data Send/Receive sequence.
This is an example of telephone number settings for the above mentioned 3 OMRON Modems.
Operand and Word Settings of PMCR
Operand 1 MD24FB10V #x561 (x: Communications port)
MD144FB5V #x571
ME1414VB2/B2 #x581
Operand 2 First address C of send data (dialling operation)
Operand 3 None
C+0 Number of words from address set for operand 2 to end of
data
4 digits BCD
C+1 Number of bytes of send data (dialling operation) 4 digits BCD
C+2
:
C+n
Send data (dialling operation)
(Fill data to left for odd numbers of bytes)
ASCII