Filter
Top Products
4-5SectionConnections
54
Previous
products
Changes required for CQM1H-series productModel numberPrevious
products
OtherWiring
Model number
C-series CPU
Units
SRM1
CPM1
CPM1A
CPM2A/CPM2C
CQM1-CPUjj-E
C200HS-CPUjj-E
C200HX/HG/HE-
CPUjj-E
C200HW-COMjj-E
No changes have been
made in wiring.
It may be possible to use the host computer
programs without alteration as long as the
same communications settings (e.g., baud
rate) are used. It may be necessary, however,
to change programs to allow for different
CQM1H command specifications.
CS1-series CPU
Unit
CS1G/H-CPUjj
No changes have been
made in wiring.
It may be possible to use the host computer
programs without alteration as long as the
CS1-series
Serial
Communications
Board or Unit
CS1W-SCB21/41
CS1W-SCU21
No changes have been
made in wiring.
same communications settings (e.g., baud
rate) are used. It may be necessary, however,
to change programs to allow for different
CQM1H command specifications.
CVM1 or
CV-series CPU
Units
CVM1/CV-CPUjj
No changes have been
made in wiring.
It may be possible to use the host computer
programs without alteration as long as the
same communications settings (e.g., baud
rate) are used. It may be necessary, however,
to change programs to allow for different
CQM1H command specifications.
CVM1 or
CV-series Host
Link Unit
CV500-LK201 Port 1:
The connector has been
changed from a 25-pin to a
9-pin connector.
Port 2 set for RS-232C:
The SG signal has been
changed from pin 7 to pin 9.
The following changes are necessary for
half-duplex transmissions that use CD.
Check the system for timing problems when
using SEND(90), RECV(98), or CMND(––) to
initiate communications from the PC or timing
problems in sending commands from the host
computer. If necessary, switch to full-duplex
transmissions.
The following changes are necessary for
full-duplex transmissions that do not use
CD.
Half-duplex It may be possible to use the host
computer programs without alteration as long
as the same communications settings (e.g.,
baud rate) are used. It may be necessary,
however, to change programs to allow for
different CQM1H command specifications.
Note The number of words that can be read and written per frame (i.e., the text
lengths) when using C-mode Host Link commands is different for C-series Host
Link Units and CQM1H-series Serial Communications Boards. A host computer
program previously used for C-series Host Link Units may not function correctly
if used for CQM1H-series PCs. Check the host computer program before using it
and make any corrections required to handle different frame text lengths.