Filter
Top Products
5-6SectionUsing Protocol Macros
83
Word ResetSetClassifi-
cation
Name and FunctionBits
IR 207
00 Port 1 Restart Bit
The communications port will be restarted when this bit is
turned ON by the user.
Port sta-
tus
User-set or
STUP(––)
After
settings are
changed
01 Port 2 Restart Bit
Same as IR 20700.
and port
restarted
02 Port 1 Continuous Trace Start/Stop Bit
The CX-Protocol will start a continuous trace when the bit
is turned ON. The trace is ended when the bit is turned
OFF.
The CPU Unit will manipulate the Shot Trace Bit and
Continuous Trace Bit when trace operations are performed
from the CX-Protocol. Do not manipulate these bits directly
from a ladder diagram.
Tracing From
CX-Protocol
From
CX-Protocol
03 Port 2 Continuous Trace Start/Stop Bit
Same as IR 20702.
04 Port 1 Shot Trace Start/Stop Bit
The CX-Protocol will start a one-shot trace when the bit is
turned ON. The trace is ended when the bit is turned OFF.
The Serial Communications Board will be cleared when
the trace buffer becomes full.
The CPU Unit will manipulate the Shot Trace Bit and
Continuous Trace Bit when trace operations are performed
from the CX-Protocol. Do not manipulate these bits directly
from a ladder diagram.
At end of
short trace
05 Port 2 Shot Trace Start/Stop Bit
Same as IR 20704.