Filter
Top Products
Appendix K3Z4L Laser Micrometer Protocol
321
• DIP Switch 2
No. Setting Status
1
Selection for
ON/OFF
2
measurement section
ON/OFF
3 ON/OFF
4 ON/OFF
5
Setting of minimum read
ON/OFF
6
value
ON/OFF
7 Display unit ON/OFF
8 External command
setting
ON/OFF
Delimiter Control Code Setting
3Z4L-4000 Series
The delimiter control codes must be set on DIP switch SW1 for the 3Z4L-4000 Series. Turn off pins 4 and 5, set the
delimiter codes to CR+LF, and set the delimiter code control setting in the sequence to CR+LF. See the setting for
CR+LF in the following diagram.
Turn OFF.
Turn OFF (to use a general-purpose interface)
Turn ON (to use a general-purpose interface)
Delimiter Setting
Delimiter
Pin
Pin 4
Pin 5
Handshaking
ON: Control (recognize DRT input)
OFF: 3-wire method (non-protocol)
Baud Rate
Baud rate
Pin
Pin 1
Pin 2
OFF OFF
OFF
ON
ONOFF
CR+LF
CR
LF
OFF
OFF
OFF
OFFON
ON
ON
ON
1200 2400 4800 9600
1 2 345 678
3Z4L-3000 Series
The delimiter control code does not need to be set on the DIP switch for the 3Z4L-3000 Series. Set the delimiter
Set these settings according
to the sensor connected.
Set these settings for
4 digits in the decimal por-
tion.