Filter
Top Products
Appendix MV600/V620 ID Controller Protocol
399
Receive Data Word Allocation (3rd Operand of PMCR)
Receive data
storage words
Number of receive data words+0
+1
(Undefined)(Undefined)
Completion code
Offset Contents (data format) Data
+0 Number of receive data
words (4 digits BCD)
0002 (fixed)
+1 Completion code
(2 digits Hexadecimal)
(Verification, calculation designation)
00: Normal completion for calculation processing
75: Data in normal condition for verification
processing
76: Error Data alarm for verification processing
(If management of number of write times is
designated)
75:Number of write times is under those which is
specified.
76:alarm for number of write times is over those
which is specified.
Note If L (management of number of write times) is designated by processing designation, management of num-
ber of write times for Data Carrier of EEPROM is performed.
Control (Sequence No. 541)
This sequence performs I/O operations or I/O reads.
Send Data Word Allocation (2nd Operand of PMCR)
First word of send
data
Number of send data words+0
+1
+2
(Undefined)
Unit No.
(Undefined)
OUT1 operation OUT2 operation
Offset Contents (data format) Data
+0 Number of send data words
(4 digits BCD)
0003 (fixed)
+1 Unit No. (2 digits BCD) 00 to 07 (CD1D)
+2
OUT1 operation (1 digit BCD) 0: No operation
1: turned ON
2: turned OFF
OUT2 operation (1 digit BCD) 0: No operation
1: turned ON
2: turned OFF
Receive Data Word Allocation (3rd Operand of PMCR)
Receive data
storage words
Number of receive data words+0
+1
Current input status
Output status after
operation
Offset Contents (data format) Data
+0 Number of receive data words
(4 digits BCD)
0002 (fixed)
+1
Leftmost 1
byte
Current input status
Leftmost 4 bits: IN1 operation
Rightmost 4 bits: IN2 operation
1: ON status
0: OFF status
Output status after operation
Leftmost 4 bits: OUT1 operation
Rightmost 4 bits: OUT2 operation
1: ON status
0: OFF status
Note 1. The V600/620-CAjA does not support this command.
2. This sequence executes the equivalent of the CONTROL command.