Filter
Top Products
set fdb 101
See Also
clear vlan on page 91
set vlan name on page 103
set vlan port on page 104
set vlan tunnel-affinity on page 105
set fdb Adds a permanent or static entry to the forwarding database.
Syntax —
set fdb {perm | static}
mac-addr port port-list vlan vlan-id [tag tag-value]
perm — Adds a permanent entry. A permanent entry does not age out
and remains in the database even after a reboot, reset, or power
cycle.
static — Adds a static entry. A static entry does not age out, but is
removed from the database after a reboot, reset, or power cycle.
VLAN State Link status of the VLAN:
Down — The VLAN is not connected.
Up — The VLAN is connected.
Tunl Affin Tunnel affinity value assigned to the VLAN.
Port Member port of the VLAN. The port can be a physical port or a
virtual port.
Physical ports are 10/100 Ethernet or gigabit Ethernet ports on
the WX switch, and are listed by port number.
Virtual ports are tunnels to other WX switches in a mobility
domain, and are listed as follows: t:ip-addr, where ip-addr is the
system IP address of the WX switch at the other end of the
tunnel.
Note: This field can include MAP access ports and wired
authentication ports, because MSS dynamically adds these ports to a
VLAN when handling user traffic for the VLAN.
Tag Tag value assigned to the port.
Port State Link state of the port:
Down — The port is not connected.
Up — The port is connected.
Table 24 Output for display vlan config (continued)
Field Description