Filter
Top Products
set radio-profile auto-tune channel-config 281
Examples — The following command configures the 802.11b/g radios in
radio profile rp1 to allow associations from 802.11g clients only:
WX4400# set radio-profile rp1 11g-only enable
success: change accepted.
See Also
display {ap | dap} config on page 237
display radio-profile on page 257
set port type ap on page 83
set radio-profile mode on page 291
set radio-profile
auto-tune
channel-config
Disables or reenables dynamic channel tuning (RF Auto-Tuning) for the
MAP radios in a radio profile.
Syntax —
set radio-profile name auto-tune channel-config
{enable | disable}
name — Radio profile name.
enable — Configures radios to dynamically select their channels
when the radios are started.
disable — Configures radios to use their statically assigned channels,
or the default channels if unassigned, when the radios are started.
Defaults — Dynamic channel assignment is enabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — If you disable RF Auto-Tuning for channels, MSS does not
dynamically set the channels when radios are first enabled and also does
not tune the channels during operation.
If RF Auto-Tuning for channels is enabled, MSS does not allow you to
manually change channels.
Examples — The following command disables dynamic channel tuning
for radios in the rp2 radio profile:
WX4400# set radio-profile rp2 auto-tune channel-config
disable