Filter
Top Products
280 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
Examples — The following command disables automatic firmware
upgrades on the MAP access point connected to port 6:
WX1200# set ap 6 upgrade-firmware disable
See Also
display {ap | dap} config on page 237
set radio-profile
11g-only
Configures each 802.11b/g radio in a radio profile to allow associations
with 802.11g clients only.
Syntax —
set radio-profile name 11g-only {enable | disable}
name — Radio profile name.
enable — Configures radios to allow associations with 802.11g
clients only.
disable — Configures radios to allow associations with 802.11g
clients and 802.11b clients.
Defaults — The default setting is disable. 3Com 802.11b/g radios allow
associations with 802.11g and 802.11b clients by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command
.
Even when association of 802.11b clients is disabled, if an 802.11b/g
radio detects a beacon from an 802.11b network, the radio enters
protection mode to guard against interference.
The set radio-profile 11g-only command does not affect the radio
support configured with the set port type ap command. For example, if
you configure a radio to be 802.11b only when you set the port type, the
set radio-profile 11g-only enable command does not enable 802.11g
support on the radio.