Filter
Top Products
228 CHAPTER 8: MOBILITY DOMAIN COMMANDS
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command sets the current WX switch as a
nonseed member of the Mobility Domain whose seed has the IP address
192.168.1.8:
WX4400# set mobility-domain mode member seed-ip 192.168.1.8
mode is: member
seed IP is: 192.168.1.8
See Also
clear mobility-domain on page 224
display mobility-domain config on page 225
set
mobility-domain
mode seed
domain-name
Creates a Mobility Domain by setting the current WX switch as the seed
device and naming the Mobility Domain.
Syntax —
set mobility-domain mode seed domain-name
mob-domain-name
mob-domain-name — Name of the Mobility Domain. Specify between
1 and 16 characters with no spaces.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — Before you use this command, the current WX switch must
have its IP address set with the set system ip-address command. After
you enter this command, all Mobility Domain traffic is sent and received
from the specified IP address.
You must explicitly configure only one WX switch per domain as the
seed. All other WX switches in the domain receive their Mobility Domain
information from the seed.