Filter
Top Products
156 CHAPTER 6: IP SERVICES COMMANDS
History —Introduced in MSS Version 3.0.
Usage — You must use an address that is configured on one of the WX
switch’s VLANs.
To display the system IP address, use the display system command.
Examples — The following commands configure an IP interface on
VLAN taupe and configure the interface to be the system IP address:
WX4400# set interface taupe ip 10.10.20.20/24
success: set ip address 10.10.20.20 netmask 255.255.255.0 on vlan taupe
WX4400# set system ip-address 10.10.20.20
success: change accepted.
See Also
clear system ip-address on page 115
display system on page 42
set interface on page 135
set timedate Sets the time of day and date on the wireless LAN switch.
Syntax — set timedate {date mmm dd yyyy [time hh:mm:ss]}
date mmm dd yyyy — System date:
mmm — month
dd — day
yyyy — year
time hh:mm:ss — System time, in hours, minutes, and seconds.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — The day of week is automatically calculated from the day you
set. The time displayed by the CLI after you type the command might be
slightly later than the time you enter due to the interval between when
you press Enter and when the CLI reads and displays the new time and
date.